...
If the component is fitted to an opening that is too large (resulting in a comp over 36” wide), a red warning ‘X’ will appear with a Max Width warning. If this happens, sure to adjust the component back to a smaller width.
...
| Info |
|---|
If the space available is under the predetermined standard width of a new component (typically defaulted to 24” when pulling over an empty component), the new component will automatically fill the space available when it is pulled over. You should not have to use this feature. |
When auto-fitting a component using this method, a blue Auto will appear at the top of the component. This means that the component is now the Design Zone’s design zone’s dedicated Auto Width component, which gives it an extra level of adjustability. There can only be one auto component per Design Zonedesign zone. Typically, this would be a component with limited parts, such as a long hang section.
...
There will now be an Auto option when hovering over the dimension lines on the other components, where you have previously seen Next and/or Move. <LINK>
If you double click to change the dimension when Auto is showing, it will change the width of the selected component, and take the size adjustment from the “auto width” component versus the ones beside it. In this example, the odd-sized double hang on the far right is the Auto unit.
...
The user can manually turn the Auto-Width feature on and off in the Component Properties menu, under Misc. The check in the box to the right means it is “on”.
If Seeing An Asterisk* By a Width Dimension..If an Asterisk (*) is displayed, it means the width measurement is a rounded value. This is because the board thicknesses are measured down the 1/10 of a millimeter, widths (especially when spanning units or filling a gap between units) may not work out to a nice fraction of an inch.  CAD will display the nearest fractional inch value but then show the * to indicate that the actual measurement differs slightly. This is seen most often on an “AutoFit” width component. Double click on the dimension to see the true width, or check it in Component Properties.  This can also be manually trigger by typing in a measurement that is just slightly off from a standard fraction (e.g. 24.124 will display as 24.125* because that is the nearest standard fraction (24 1/8”).
|
AUTOFIT COMPONENTS WITH “HOT EDGES”
Using “Hot Edges” is another method to auto-fit a component. When placing an empty component (or a pre-designed component template) in the available space, notice the two bright green “bars” that appear on either side of the gap. Before left clicking to place the component, move the cursor over one of bars to prompt the component to fill the space.
...
If the curser isn’t directly over one of the bars, the component will come in at the defaulted width (ei. 24”). This is an option if choosing to keep a gap instead of filling the space. Left click to place.
...
| Info |
|---|
The new comp will automatically share partitions with existing comps if “Auto Partitions” is enabled. |
...
RELATED PAGES:
...
ghg <LINK>
...