If you want to In order to successfully design a component that has any kind of pull-out (beside drawers) behind a door, you will it need to have an offset piece(s) for the runners/glides to clear the door hinges. A TFL cleat is the primary type of offset piece.
...
Start by adding the desired pull-out parts to your the component, like such as baskets, pull out shelves, or hampers. Drawers will be discussed a little bit later, as they behave differently. Next, add an Ext. Door <LINK> to your the component. It should automatically cover all your parts (far left), the pull-out parts unless they have fronts themselves . You can also place pull outs after you have a door (drawers must be faceless) <LINK>. Pull outs can also be placed after the door is in place.
GIF
...
Once the door is placed, you will get offset warnings on all the pull outs. Depending on the hinge direction of the door, you will see “Required offset on left/right/both sides” (see left). This will coordinate with the side of the door that has the hinges.
...
sdfsdfd
...
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>