Page Comparison

When adding a new component, moving the cursor up/down before placement will determine the mounting type <LINK>. There are various ways to change mounting type after the component is in the Design Zone.

1

Quickly and easily change an off-the-floor component to a to-the-floor by hovering near the bottom of the component until an arrow appears. The arrow will turn green when ready to be clicked. Click on that arrow to extend the component to the floor. A toe kick will automatically be added.   Info Note that this method only works one way; This method does not work to switch to a wall system from a floor system.

2

Switch back and forth between component mounting types by going into the Properties [Comp] menu and changing the Mounting Type under the Construction heading. This change can be applied to multiple components if desired using the Apply To options. Note Depending on certain the component and parts, certain parts may shift when changing mounting types. If this happens, manually adjust the parts afterwards. You may also notice width changes in components against a wall with floor molding.

...

 
When the Auto Update Height feature box is checked, it will lock the height of certain parts (such as hanging poles) when the toe kick is added. This ensures that the distance between the hanging pole and the floor (the hang height) remains the same. However, this will change the top shelf height to accommodate.

...

...

...

RELATED PAGES:

• ghg <LINK>

• ghgh <LINK>