...
Add the desired layout of drawers to a component. In the drawer Properties [Part], under the Front heading, change all but the bottom drawer of the orientation to Faceless <LINK>. Use the apply properties to change multiple drawers at once.
...
Info |
---|
Check the Standard Product Guide (found in the CAD “Help” tab <LINK>CONFIRM!!) for common orientations and restrictions. |
...
There are several ways to satisfy the pinch point warning in Properties [Part]:
1 | Add a scoop to the front of the box. <LINK>(Scoop under Box subheading) |
---|---|
2 | Change the slides to Push to Open/P2O (Slide under Box subheading). |
3 | Add more space by changing the drawer size to “Custom” and adding more height - One additional numerical value is the minimum, ex. from a 5 to 6 (Size under Assembly subheading). |
4 | Change the size of the drawer box to be smaller than the assembly size (Size under Box subheading). |
Info |
---|
The user can remove the shelves above or below if not wanted/needed. This feature is located in the drawer properties, under the Misc subheading - Change the Shelf Above/Below drop down from “Auto” to “Off”. |
...
Info |
---|
The size of the drawer(s) can still be adjusted using the + and - after it is in place. |
...
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>