This section explores methods for editing a basic space and/or walls after completing the Setup Wizard.
EDIT WALL LENGTHS
There are 3 ways that to change the wall dimensions in a design. All but the last method can be used with the Setup Wizard still open.
...
2. Double click on the wall dimension (the dimension will turn red when hovering over them) and manually replace the number by typing. Make sure to hit Enter on the keyboard or the number will not apply.
...
Delete a wall by right clicking on the desired wall, which turns red when hovering over it, and select Delete. This will not affect the other walls in the design. This is helpful if the user needs to edit the shape of a room.
...
To start completely over (but maintain the room details such as ceiling height, base molding, etc.), right click anywhere on the Plan View (not on the walls or design zones) and select Delete All.
...
CHANGE WALL TYPE
To change the wall type after exiting the Setup Wizard, change the drop down option in the Room section of the Plan ribbon toolbar. This will apply to all walls in the design.
...
To change wall type for a single wall, right click on a wall and select Properties [Wall]. Select from the Type drop down. Users can also turn a label on which will make it clear that the wall type is different. This shows in both Plan and ELV views.
...
CHANGE ROOM MOLDING
...
To change the base molding of the wall(s) after exiting the Setup Wizard, right click on a wall and select Properties [Wall].
...
This will allow the user to set different molding instruction or dimensions per wall, if desired. To apply an changes to the entire room, ensure the boxes to the left are all checked, and use the Apply Properties To.. Room at the bottom of the wall properties dialogue.
...
CHANGE CEILING HEIGHT
...
To edit the ceiling height after exiting the Setup Wizard, do so from the Plan view ribbon toolbar. Type a new number in the Ceiling Height field under the Room heading and press Enter on the keyboardto apply.
The change will not be visible in the Plan view, but the change can be confirmed in Elevation view.
...