Mini drawers are popular additions to offices, vanities, or anywhere else you need smaller storage solutions are needed. They are created by placing drawers between strategically set uprights in a component.
...
| Info |
|---|
The minimum width for mini drawers is in an 8” wide section – Typically, a 24” wide section will have two mini drawers, and a 30” wide can have two or three. |
...
Begin by adding any parts that will sit below your the mini drawers, as necessary, such as other full-sized drawers, as seen in the image to the left.
Consider the height of your the mini-drawers. Most of them will tend to be small or medium-height frontsassemblies. Add a single fixed shelf above the starting point with enough room to fit the drawer , plus some extra. Next, Then add your an upright between the fixed shelves to create a half or thirds- split in your component (right, top).
Note: If the space is too tight, you will get a “height not allowed” warning when adding your drawers (right, bottom).
Add your drawer using the drawer (s) in the component.
...
Add drawers using the Drawer tool, scrolling to resize the assembly as needed. The custom width will appear as a label on the front of the drawer. Finally, using the – (minus) button on the fixed shelf above the mini drawers, lower the shelf until it sits right on top of the drawers (see left). .
...
| Note |
|---|
If the space is too short for the drawer being added, you will get a “height not allowed” warning when adding. |
Repeat the previous steps to add as many stacks of mini drawers as desired.
...
...
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>Drawers