Mini drawers are popular additions to offices, vanities, or anywhere else smaller storage solutions are needed. They are created by placing drawers between strategically set uprights in a component.
...
| Info |
|---|
The minimum width for mini drawers is in an 8” wide section – Typically, a 24” wide section will have two mini drawers, and a 30” wide can have two or three. |
Begin by adding any parts that will sit below the mini drawers, as necessary, such as other full-sized drawers or base cabinets.
IMG
Consider the height of the mini-drawers. Most tend to be small or medium-height assemblies. Add a single fixed shelf above the starting point with enough room to fit the drawer , plus some extra. Then add an upright in between the fixed shelves to create split(s) in the component.
GIF
| Note |
|---|
If the space is too tight, you will get a “height not allowed” warning when adding drawers. |
...
Add drawers using the Drawer tool <LINK>, scrolling to resize the assembly as needed. The custom width will appear as a label on the front of the drawer. Finally, using the – (minus) button on the fixed shelf above the mini drawers, lower the shelf until it sits right on top of the drawers.GIF
...
| Note |
|---|
If the space is too short for the drawer being added, you will get a “height not allowed” warning when adding. |
Repeat the previous steps to add as many stacks of mini drawers as desired. 3D IMG
...
...
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>Drawers