Mini drawers are popular additions to offices, vanities, or anywhere else you need smaller storage solutions. They are created by placing drawers between uprights in a component. The minimum width for mini drawers is in an 8” wide section – Typically, a 24” wide section will have two mini drawers, and a 30” wide can have two or three.
Begin by adding any parts that will sit below your mini drawers, such as other full-sized drawers, as seen in the image to the left.
Consider the height of your mini-drawers. Most of them will be small or medium-height fronts. Add a single fixed shelf with enough room to fit the drawer, plus some extra. Next, add your upright to create a half or thirds-split in your component (right, top).
Note: If the space is too tight, you will get a “height not allowed” warning when adding your drawers (right, bottom).
Add your drawer using the drawer tool, scrolling to resize as needed. The custom width will appear on the front of the drawer. Finally, using the – (minus) button on the fixed shelf above the mini drawers, lower the shelf until it sits right on top of the drawers (see left).
Repeat the previous steps to add as many stacks of mini drawers as desired.
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>