Users can change the depth of components, either individually or for multiples, in Properties [Component]. The depth of the Design Zone will dictate the depth of any new, empty component.
If working with multiple components with doors or pull outs, it may give a warning or automatically double par when changing the component depth <LINK>. If only changing the depth of one component and not the others, for example with a 24” deep drawer bank with 14” components on either side, a double par may be required and should remain - Refer to a plan reviewer with any questions.
If intending to apply the depth to the rest of the design zone, users will want to remove the double partitions because they are not necessary. This can be done under Construction in Properties [Component]. Uncheck the box(es) for left or right partitions as needed. However, this method will also auto-adjust the widths, and it creates a lot of extra work.
GIF
The easiest way to approach this scenario is to plan before changing depths. If users uncheck the Auto Partitions box in the ribbon toolbar, it will stop components from double parring.
GIF
Users may get a warning that states “Invalid Partition Depths” but this will disappear once the depth change is applied to the wall. This method will save a lot of time and energy.
RELATED PAGES:
ghg <LINK>
ghgh <LINK>