In order to successfully design a component that has any kind of pull-out behind a door, it need to have an offset piece(s) for the runners/glides to clear the door hinges. A TFL cleat is the primary type of offset piece.
Drawers behave slightly different than what is explained below. See this <LINK> article for information.
Start by adding the desired pull-out parts to the component, such as baskets, pull out shelves, or hampers. Drawers will be discussed a little bit later, as they behave differently. Next, add an Ext. Door <LINK> to the component. It should automatically cover all the pull-out parts unless they have fronts themselves (drawers must be faceless) <LINK>. Pull outs can also be placed after the door is in place.
Once the door is placed, there will be offset warnings on all pull-outs. The warning will say “Required offset on left/right/both sides” depending on the hinge direction.
To add cleats to the runners, right click on the pull-out and select Properties [Part]. There is a heading for Offsets. The user can choose the side(s) for the offset hardware, the height, and the finish.
The Finish will dictate the thickness of the cleats.
When adding a cleat to the glide(s), the width of the component will automatically change to compensate. If you select the wrong side(s) the warning may change or remain.
The cleats are visible in the elevation and 3D views. Click to zoom.
Due to the component widths automatically adjusting, it may require users to move components around if there are other components around it or if the design is wall-to-wall, as it can push components outside of the Design Zone. Components can also be autofitted <LINK> if they do not need to be a standard width.
Use the Apply Properties To.. at the bottom of the part properties to add cleats to additional parts, but note that this will only apply to like parts.
If resizing a component with cleats, users will get a width not supported warning if the parts require a standard width; This will prompt them to change the component back to an appropriate width.
IMPORTANT: Be careful of applying pull-out offsets, only apply to the Component or Select other parts. This will avoid accidently adding cleats to pull outs on other components, where they may not be wanted or required.
CLEAT THICKNESS (CONFIRM WITH TIM)
A narrower cleat (3/4” material) is the standard go-to for most items, as it is enough to clear a door with a standard hinge. If the pull out sits directly behind a hinge, a thicker cleat (1-1/8” or 1-3/16”) is required to clear the hinge. However, a cleat cannot sit directly behind the hinge and the hinges will appear with a red warning.
It is also required to have a thicker cleat for drawers behind doors <LINK>.
Users can check the hinge location by going up to the Display section of the ELV ribbon toolbar and check the box next to Hinges. Any hinge interference will be represented as a red warning. Plan reviewers can manually move the location of the hinge.
The thickness of the cleat can be changed in the Properties [Part] of the pull-out by selecting the Finish under the Offsets heading.
RELATED PAGES:
fghfghfgh<LINK>
fghfgh<LINK>