This section explores methods for editing a basic space and/or walls after completing the Setup Wizard.
EDIT WALL LENGTHS
There are 3 ways that to change the wall dimensions in a design. All but the last method can be used with the Setup Wizard still open.
When adjusting the lengths of the walls, the Design Zone will automatically adjust to fit.
1. Click on the wall, hold, and drag it into a position. Note that this is not the most accurate method.
2. Double click on the wall dimension (the dimension will turn red when hovering over them) and manually replace the number by typing. Make sure to hit Enter on the keyboard or the number will not apply.
3. Right click on a wall, select Properties [Wall] and manually change the number beside the Length field. This is where users can also adjust the base molding options, wall color, and create angled ceilings.
Delete a wall by right clicking on the desired wall, which turns red when hovering over it, and select Delete. This will not affect the other walls in the design. This is helpful if the user needs to edit the shape of a room.
To start completely over (but maintain the room details such as ceiling height, base molding, etc.), right click anywhere on the Plan View (not on the walls or design zones) and select Delete All.
CHANGE WALL TYPE
To change the wall type after exiting the Setup Wizard, change the drop down option in the Room section of the Plan ribbon toolbar. This will apply to all walls in the design.
To change wall type for a single wall, right click on a wall and select Properties [Wall]. Select from the Type drop down. Users can also turn a label on which will make it clear that the wall type is different. This shows in both Plan and ELV views.
CHANGE ROOM MOLDING
To change the base molding of the wall(s) after exiting the Setup Wizard, right click on a wall and select Properties [Wall].
Under the Dimensions heading, there will be a will see options for Floor Molding. This is where users can either add, remove, or adjust molding that was set initially.
If making any changes, it will only apply to the one wall whose properties are being edited.
This will allow the user to set different molding instruction or dimensions per wall, if desired. To apply an changes to the entire room, ensure the boxes to the left are all checked, and use the Apply Properties To.. Room at the bottom of the wall properties dialogue.
CHANGE CEILING HEIGHT
To edit the ceiling height after exiting the Setup Wizard, do so from the Plan view ribbon toolbar. Type a new number in the Ceiling Height field under the Room heading and press Enter on the keyboard to apply.
The change will not be visible in the Plan view, but the change can be confirmed in Elevation view.
RELATED PAGES: