Page Comparison

The ASSEMBLY heading contains the option to change the drawer Size (reflects in the face and drawer), select a File drawer, or to create Custom assemblies outside of the standard sizes, where you can input the number of spaces the assembly will take up.

The FRONT heading contains drop down selections that allow the user to change the Type, Style, and Finish. The Style and Finish options will coordinate with the selected Type.

The grain direction for drawers defaults horizontally. Rotate Grain is used (checked) if wanting to turn the grain vertically.

Extend to Faceless is an option used when placing multiple boxes behind a single front.

Users can also adjust Front Overlays, which determine how much of the partition is covered by the face.

The fields under the Dimensions heading provide a quick reference to the drawer face size. These do not need editing.

The Hardware heading will allow users to select from handle, knob, or finger pull options. Depending what Type is selected, the Style and Finish options will vary. There are also options to add double hardware (for wide drawers) as well as positioning and drilling notations (not often adjusted by design consultants).

Just below this is where users can add Lock(s) to any drawers.

The BOX heading allows the user to change the box Size, as it is not uncommon to have a larger face on a smaller box.

The depth of a box can be adjusted under the Dimensions heading, although the user can only select depths acceptable based on the depth of the component.

The type of Slide, drawer box Construction and Finish, and File rail orientations can be edited her.

Insertscan be added using the various filtered drop downs.

The MISC heading contains the options for manually manipulating the Shelf Above or Below a drawer. Users can turn Depth Label(s) on/off, which will appear on the front of a drawer in the Elevation view.