The depth of the design zone will dictate the depth of any new, empty component. However, users can change the depth of components, either individually or for multiples, in Properties [Component]. Change the number in the Actual Depth field.
It is helpful to have the Depths label turned on to quickly view the component depth, especially if there are various depths in a design zone. This can be found in the Display section of the Elevation ribbon toolbar.
If working with multiple components with doors or pull outs, it may give a warning or automatically double par when changing the component depth. If only changing the depth of one component and not the others, for example with a 24” deep drawer bank with 14” components on either side, a double par may be required and should remain - Refer to a plan reviewer with any questions.
Users may want to remove the double partitions because they are not always necessary. This can be done under Construction in Properties [Component]. Uncheck the box(es) for left or right partitions as needed. However, this method will also auto-adjust the widths, and it creates a lot of extra work.
The easiest way to approach this scenario is to plan before changing depths. If users uncheck the Auto Partitions box in the ribbon toolbar, it will stop components from double parring.
Users may get a warning that states “Invalid Partition Depths” but this will disappear once the depth change is applied to the wall. This method will save a lot of time and energy.
RELATED PAGES: