UNDER REVIEW
This page explains the steps to take for installing standard TFL adjustable shelves. Prior to beginning the installation, ensure you completed all steps of installing the system skeleton.
Page Contents
Skill Requirements
Tools & Hardware
Installation Steps
Related Training Materials
Final Steps & Delivery
Certification
Terms & Definitions
Types of Installation: Off-the-Floor, Floor-Based
Installer Level Required: Jr. Apprentice Installer
Products Required: TFL Material
Hardware Required
Adjustable Shelf Pins
Installation Steps
Personal Protective Equipment (PPE) must be worn at all times when handling material and operating the power tools mentioned throughout this process. Review the PPE Matrix for further guidance.
Ensure the adjustable shelf pins are in the partitions in the correct locations. This should be done while prepping the partition.
Ensure all shelf pins are facing the correct direction; flat side up.
If there is backing, adjustable shelves and their pins must be inserted after backing is installed.
Shelf pins inserted in partitions
Locate the shelves in the staging area.
Double check the measurements on the BOM and label to ensure the correct sizes are being placed in the correct location(s).
Adjustable Shelf on the parts list
Inspect the shelf for chips or damage, and touch up any chips.
Inspect the shelf prior to removing the sticker in case the shelf needs to be replaced due to damage.
Place shelf on the shelf pins.
Installed adjustable shelf
Related Training Materials
Skeleton Fundamentals
Complete the Installation
System Touch Ups
Cleaning the System & Jobsite
Delivery to the Customer
PPE Matrix
Final Steps & Delivery
Inspect the installation and complete any touch ups if necessary.
If there are no more components to install, remove all stickers/labels.
If there are no more components to install, complete the clean up process.
If there are no more components to install, complete the Professional Installation Experience by walking through the space with the customer and delivering the final product.
Certification Steps:
Proper shelf pins have been used.
Shelf has been inspected for chips or damage, and repaired if needed (See Touch Ups)
Shelf has been put in the correct location according to system elevations.
Terms & Definitions
BOM | Bill of Materials; Parts List |
Elevation | The CAD Design Plan created by the Design Consultant with the client. |
Add Comment