TABLE OF CONTENTS

Press-in backing was first introduced with the Paxton collection and has since been expanded to be an option in Classic systems, with some additional enhancements included.

Open

Open

What is Press-In Backing?

Press-in backing (commonly referred to as PIB) differs from other backing options in the way it looks and how it is installed. It still utilizes the wall-mounted rain system for installation, but the rail is hidden through the use of a flat suspension bracket. The 3/4” backing material is attached using press-fit cams. This combination allows full concealment of the wall mount system to give look of custom built furniture.

In CAD, press-in backing splits to multiple panels by default, while users have to manually split other styles of backing. This results in lighter material that is much easier to install, manage lighting wires, and remove if needing to service behind it.

Press-In Backing Features

Here are some of the CAD features and enhancements included as part of the press-in backing release:

• Components automatically adjust to needed depth

• Control over individual panels (more information below)

  • Designate where panel splits

    • Automatically splits at fixed shelves

    • Can be controlled manually in properties

    • Additional functionality to split at topmost fixed shelf and any lit fixed shelf (“Split Only At Lit Shelves” located in Comp Properties, more information below).

  • Grain direction (now available for all backing styles)

  • Depth of panel

• CAD automatically removes backing where it cannot be seen

  • Behind drawers

  • Behind Everstyle when in Drawer Mode (if face completely covers section)

• Additional suspension rail and bracket functionality, documentation coming soon

Here is a short video outlining some of the CAD enhancements mentioned above. This video

Add Press-In Backing

Like other backing styles, press-in backing can be applied and edited using either the materials tab or in component properties. This can be done before or after parts are added.

As with all backing, if the molding in the room interferes, users will see a warning message. To resolve, users
must increase the component depth or change the height of the bottom shelf offset.

Users will see the location of the cam locations in the elevation view, along with the standard outline and diagonal hatch lines to represent backing.

Press-in backing automatically splits at every fixed shelf (slanted shoe shelves not included). It is required to have a minimum of two panels per component (at least one fixed shelf splitting).

Edit Press-In Backing

Shelf Properties

Users can manually adjust the splits in the backing panels in Properties [Part] of the shelf where the split will be revised. Right click to access the menu, click on the “Backing” heading, and change the Back Recess to “On”. The panel will now run behind the shelf instead of splitting.

Shelf properties is also where users can find the ability to remove backing below the shelf, and change the finish, back offset (if wanting the panel to sit more forward) and grain rotation (also found in component properties, as mentioned below). This will only impact the panel that sits directly below the shelf being edited.

Component Properties

Additional edits to backing panels can be made in Properties [Component], as with other backing styles. This is where users can edit fields such as style, backing finish, and the option to rotate the backing panel grain direction. Backing defaults to vertical grain direction, so check the box if wanting to rotate to be horizontal (will receive a warning if dimensions are not supported).

If designing with custom drilling or corner shelves, as fixed shelves are required, users may not want the panel to split at every shelf which is the default. This will result in less panels and easier install.

To prevent this from happening, users can go to Properties [Component] and check the box next to Split Only At Lit Shelves.

When checked, the panel will split at the topmost fixed shelf below the suspension bracket, but not at any other below that. This means the shelves will sit in front of the backing, allowing the installer to still adjust the suspension bracket as needed but allows flexibility to adjust the other shelves down the road.

However, if adding lighting to these fixed shelves, the backing will split as intended.

RELATED PAGES:

• Backing