Fixed Shelves
- Aleeshya Broome
Table of Contents
03. Skeleton Fundamentals
This page explains the steps to take for installing a standard TFL fixed shelf. Prior to beginning this process, ensure the rail has been hung and partitions are prepped and hanging on the rail for all spaces.
Page Contents
Skill Requirements
Tools & Hardware
Installation Steps
Related Training Materials
Next Steps
Certification
Tips from the Field
Terms & Definitions
BOM Codes
Types of Installation: Off-the-Floor, Floor-Based, Wall Bed
Installer Level Required: Jr. Apprentice Installer
Products Required: TFL Material
Pozi #2 Screwdriver
Angle Ratchet Pozi #2
Hardware Required
Fixed Shelf Rafix Pins
Rafix Double-Ended Dowel (Optional)
Personal Protective Equipment (PPE) must be worn at all times when handling material and operating the power tools mentioned throughout this process. Review the PPE Matrix for further guidance.
Ensure the Rafix pins are in the partitions in the appropriate locations. This should be done while prepping the partition.
If shelves are being installed on either side of a shared partition, double-ended dowels may be used and inserted from left to right.
Locate the shelves in the staging area.
Double check the measurements on the BOM and the label to ensure the correct sizes are being placed in the correct location(s).
Inspect the shelf for chips, damage, and missing or damaged Cams.
Check the Cams and ensure they are positioned in the shelf correctly and in the open position.
Set the shelf on the Rafix screws and ensure the Cams are sitting on each screw.
Keep fixed shelves right side up. As these shelves are load bearing, it is important they are installed with the Cam side facing the bottom of the system.
Tighten each Cam clockwise until they stop turning using a Pozi #2 bit screwdriver.
Check the shelf for tightness. Gently push upwards to make sure it is locked in place.
Repeat for all remaining shelves, as indicated by an X on the elevation.
Skeleton Fundamentals
PPE Matrix
Product Feedback Form
Next Steps: Level, Plumb, Secure the System
Tips from the Field
Tips submitted by fellow installers and leaders in the field. These optional tips are intended to make this install process simpler.
Click here to submit your own tip from the field.
BOM | Bill of Materials; Parts List |
Elevation | The CAD Design Plan created by the Design Consultant with the client. |
BOM Codes
The purpose of this section is to provide guidance when confirming details on the BOM. This list includes all individual parts typically associated with this process.
SF | Shelf Fixed |
TS | Top Shelf |
VB | VB; Verbindungen |
The codes in the table above are directly from the Corporate CAD database and may not reflect all codes included in the Supported Franchise Database or Independent Franchise Databases.