...
In the elevation view, add a to-the-floor component and position it with the partition touching the wall where the two design zones overlap. This becomes the the dominant corner or dominant component. Next, add fixed shelves the component - They can be added as a multi-shelf group or individually. Alternatively, use a template that matches the criteria mentioned.
...
...
Using the green arrows, navigate to the design zone on the next wall over (adjacent wall). A bridging component may already exist. This will be the secondary/non-dominant component.
...
| Info |
|---|
If there is not a bridging component, add one manually. |
...
Right click on the bridging (non-dominantsecondary) component and select Join Corner.
This will automatically replicate the fixed shelf orientation on the original (dominantprimary) component to match.
This creates a corner component with connected shelves that will be visible in the adjacent view.
...
If using a bridging shelf that does not have any partitions(using the one provided, or using the template), the component will be open on the side. Manually add partitions in the Component Properties, or leave as is if placing additional components next to it. There will not be a missing partition warning!
...
If the user moves the individual shelves in the bridging component, or uses the + and – to adjust the number of shelves if using a multi-shelf group, the same changes will automatically apply to the dominant component. They are now synced up.
...
The corner shelf unit is still made up of two separate components, so users can adjust the widths or depths of the dominant or non-component sides the same way as with standard components.
A wall mounted component does not automatically join the fixed shelves when prompted to Join Corner. To force a corner, left click, simply grab hold and drag the “bottom” of the bridging component down to meet the bottom of the dominant primary component’s partition. Then right click and select Join Corner. If the partitions on the non-dominant secondary and dominant primary components are the same length, the join corner unit should be successful.
...
| Info |
|---|
Alternatively, the partition length on the bridging component can be changed to match the dominant component using the Height field in Component Properties. |
There are minimum and maximums widths for corner shelving units based on the weight rating for the shelving. This is to be considered for both the dominant and non-dominant side.
For instance, if the maximum is 30” x 30” at the user’s location, the dominant component can be 30” wide, but the non-dominant must be less than 30” when adding the width + the depth of the dominant wall component.
...