...
...
...
...
...
A
...
“box in
...
box” design is a box that made of TFL material that sits inside a component. They are typically made from a different
...
finish for contrast, and
...
can be offset back to create
...
a change in depths.
...
To build
...
a box in a box, start with an empty component
...
and add
...
fixed shelves and/or
...
...
If |
...
using a |
...
shelf group for adding |
...
fixed shelves, |
...
it must |
...
be exploded before adding a box in a box. |
...
Box in Box is found in the Specialty Storage dropdown in the Parts section of the ELV ribbon toolbar.
Select Box in Box. Place the box between the fixed shelves and verticals. The box will automatically
...
fill to the
...
width and height of the available space.
...
| Note |
|---|
Users will receive a warning if the box interferes with the suspension rail or if the height is too tall to be supported |
...
Just as you can with other parts, you can double click on your interior box to move it within your component, or between different components. You can right click to move or delete your interior box.
...
. The second issue can be avoided by adjusting the shelf spacing so it is shorter. |
Boxes move and delete like other parts.
Users can add additional parts such as backing, shelves, uprights, doors and lighting to the box if desired. Below shows the elevation and 3D views of a design with a variety of finishes, depths, panels, and parts.
Box In Box Properties
Right click on the box to access the
...
Properties [Part]
...
.
...
The following adjustments can be found here:
...
...
DIMENSIONS:The box
...
defaults to sit back from the front of the pars
...
/shelves.
...
Users have the ability to make them shallower or deeper, or even to extend forward and overhang if desired(add a negative number to Offset Front).
...
The Offset Back would have the box sit forward off the wall, in case
...
of backing
...
or
...
interference with the suspension rail
...
...
/brackets (typically ~4” is needed to clear the suspension rail, but refer to a plan reviewer for specific information).
BACKING PANEL: Check the box to the right of backing panel to add system backing to the box-in-box. This field offers TFL board selections
...
. Decorative
...
panels can also be added to the box using the Panel
...
...
tool, but they may be trickier to edit. If using this method, add panels before adding additional parts in the box.
MISC: Select the main finish Material of the box
...
...
You can add additional parts such as shelves, uprights, doors and lighting to your box if desired. Below shows the elevation and 3D views of a design with a variety of finishes, depths, panels, and parts.
...
These elevation and 3D views show a variety of different box-in-box designs including shelves, vertical shelves, panels, backing and doors.
Information on these parts can be found throughout this manual.
RELATED PAGES:
...
fghfghfgh<LINK>
...
, which will apply to the top, bottom and sides. The Drilling patterncan be changed, this affects the holes on the uprights of the box.
...