This process is to be completed at the start of the shift. 

1. Walk around cage and visually check stacks, noticing any that appear low.

2. Go to computer terminal in the status bar on the screen you can hover over the stacks that are low and it will give you the percentage.

3. Using the Hilo go and get the respective material open the bunk and load it into the infeed station.

4. Pull the cord once loaded to reset the station.

5. Go to infeed station tab on the computer module and name the color and quantity of the material you just loaded into the infeed station.

6. Click on the infeed station hold and drag that to the spot that needs to be filled.

7. The robot will fill the spot periodically when it is not being pulled to the saws.