Cable Management Accessories

Table of Contents
Section Header

IN REVIEW

This page outlines the process for installing various types of cable management accessories. Prior to completing any of these processes, ensure you have completed installing the system skeleton and any other parts involving the accessory.

Page Contents

Types of Installation: Off-the-Floor, Floor-Based, Virtuoso, Wall Bed, Paxton, Martha Stewart

Installer Level Required: Jr. Apprentice Installer

Products Required: Accessories, Special Order

Tools Required

Open

Drill Driver/Impact Drill

Open

Tape Measure

Utility Scissors

Hardware Required

Installation Steps

V-Shaped Cable Holder & Cable Clamp

1. Verify location as indicated by the elevation and orient side-to-side.

   1. If multiple holders are being used, keep them in line with each other and space evenly.

   2. There should be no more than 24” between holders to reduce cable sag.

2. Mount using (4) ¾” screws.

J Wire Management

1. Verify location as indicated by the elevation.

2. Cut piece to size using utility scissors

   1. J Wires are pre-cut in common sizes: 18", 24", 36", 48", 60", 72", 96"

   2. Ensure there is space (2.5”) allotted on either side for cords to run without being pinched.

3. Mount to the underside of the countertop or side of a partition using included adhesive.

   1. For additional security, mount using 3/4” panhead screws or a 3/4” screw with 1/4” washer every 12” - 18”

4. Demonstrate to the customer how to tuck cords into the channel.

Related Training Materials

Skeleton Fundamentals
Complete the Installation
System Touch Ups
Cleaning the System & Jobsite
Delivery to the Customer
PPE Matrix
Product Feedback Form

Final Steps & Delivery

1. Inspect the installation and complete any touch ups if necessary.

2. If there are no more components to install, remove all stickers/labels.

3. If there are no more components to install, complete the clean up process.

4. If there are no more components to install, complete the Professional Installation Experience by walking through the space with the customer and delivering the final product.

Tips from the Field
Tips submitted by fellow installers and leaders in the field. These optional tips are intended to make this install process simpler.

Click here to submit your own tip from the field.

Terms & Definitions

BOM Codes
The purpose of this section is to provide guidance when confirming details on the BOM. This list includes all individual parts typically associated with this process.

The codes in the table above are directly from the Corporate CAD database and may not reflect all codes included in the Supported Franchise Database or Independent Franchise Databases.