Wrap Panel
- Aleeshya Broome
Table of Contents
Apprentice to Journeyman Installer
This page explains the steps to take for installing a wrap panel. Prior to beginning the installation, ensure you completed all steps of hanging system rail and prepping partitions.
Page Contents
Skill Requirements
Tools & Hardware
Installation Steps
Related Training Materials
Final Steps & Delivery
Certification
Tips from the Field
Terms & Definitions
BOM Codes
Types of Installation: Off-the-Floor, Floor-Based, Wall Bed
Installer Level Required: Apprentice Installer
Products Required: TFL Material
Measuring Tape
18-Gauge Nail Gun
Clamp
Countersink Bit
Hardware Required
18-Gauge 1 1/4” Nails
18-Gauge 1 1/2” Nails
18-Gauge 2” Nails
1 1/4” x #8 Screws
1 5/8” x #8 Screws
2” x #8 Screws
Personal Protective Equipment (PPE) must be worn at all times when handling material and operating the power tools mentioned throughout this process. Review the PPE Matrix for further guidance.
Locate all materials. Wrap panels can be single pieces or multiple pieces in a stack.
If you are completing a multi-stack, pay close attention to the elevation to understand the orientation. If it is not clear, speak with the design consultant or your install manager for clarification.
Dry fit the pieces to ensure all dimensions are correct and review where the attachment points are. Note where all shelves are located on the partition.
Beginning from the bottom, place the partition on top of the first wrap panel.
Attach the panel to the partition.
Multi-Stack Only: Place the next panel under the partition and follow step 5 to secure it in place.
Ensure all nail holes are touched up.
Skeleton Fundamentals
Complete the Installation
System Touch Ups
Cleaning the System & Jobsite
Delivery to the Customer
PPE Matrix
Inspect the installation and complete any touch ups if necessary.
If there are no more components to install, remove all stickers/labels.
If there are no more components to install, complete the clean up process.
If there are no more components to install, complete the Professional Installation Experience by walking through the space with the customer and delivering the final product.
Certification Steps:
Panels are flush against the partition and secured with no gap.
Screws are placed at each fixed shelf location and concealed by the fixed shelf.
Nails are placed in each corner and every 12 - 18” along the front and back of the panel, continuing up the height of the component.
Nails are hidden behind fixed and adjustable shelf locations.
All nail holes have been touched up.
Tips from the Field
Tips submitted by fellow installers and leaders in the field. These optional tips are intended to make this install process simpler.
Click here to submit your own tip from the field.
BOM | Bill of Materials; Parts List |
Elevation | The CAD Design Plan created by the Design Consultant with the client. |
Dry Fit | Holding material or accessory in its intended location to test size accuracy. |
BOM Codes
The purpose of this section is to provide guidance when confirming details on the BOM. This list includes all individual parts typically associated with this process.
BW | Backing Wrap Panel |
EP | End Panel |
PW | Partition Wrap Panel |
The codes in the table above are directly from the Corporate CAD database and may not reflect all codes included in the Supported Franchise Database or Independent Franchise Databases.