Office Accessories: Wall-Mounted

Table of Contents
Journeyman to Senior Installer

IN REVIEW

The purpose of this page is to outline the process of installing or attaching multiple office accessories, including magnetic marker boards and fabric/tack boards. If you are installing a non-magnetic marker board, review the press-in panel instructions.

Page Contents

Types of Installation: Off-the-Floor, Floor-Based, Wall Bed

Installer Level Required: Journeyman Installer

Products Required: Accessories, Special Order

Tools Required

Open

Drill Driver/Impact Drill

Open

Tape Measure

1/2” Drill Bit

Hardware Required

Installation Steps

Marker Boards

1. Determine the height of the board based on the elevation. If this is not noted, reach out to the design consultant.

2. On the board, measure from top of the panel down to the center of the pre-drilled hole in the bottom z-cleat. Note this measurement on a piece of paper.

3. Repeat taking this measurement for the bottom z-cleat. Note this measurement on a piece of paper.

4. Remove tape to separate the pieces of the Z cleat and remove bottom track

5. Measure from floor to elevation’s indicated height of the accessory.

6. Referring to your noted measurements, mark both cleat measurements on the wall.

7. Draw a level line for both bottom cleats.

8. Place the bottom cleat on the wall, with the line centered on the holes.

9. Determine location of studs for securement points. Drill for any toggles using a 1/2” drill bit.

9. Secure using 2 1/2” screws and toggles through all holes on the bottom cleats.

10. Hook the board onto the bottom cleats.

Fabric/Tack Boards

1. Complete the full installation of the adjacent or surrounding system.

2. Measure the area for the board to ensure the tack board will fit.

3. Place circles of liquid nails on the back of the tack board; one in each corner.

4. Place the tack board on the wall and hold in place.

5. Secure in place using 1 1/4” nails. Ensure they sit below the fabric so they are not seen.

Related Training Materials

Skeleton Fundamentals
Complete the Installation
System Touch Ups
Cleaning the System & Jobsite
Delivery to the Customer
PPE Matrix
Product Feedback Form

Final Steps & Delivery

1. Inspect the installation and complete any touch ups if necessary.

2. If there are no more components to install, remove all stickers/labels.

3. If there are no more components to install, complete the clean up process.

4. If there are no more components to install, complete the Professional Installation Experience by walking through the space with the customer and delivering the final product.

Tips from the Field
Tips submitted by fellow installers and leaders in the field. These optional tips are intended to make this install process simpler.

Click here to submit your own tip from the field.

Terms & Definitions

BOM Codes
The purpose of this section is to provide guidance when confirming details on the BOM. This list includes all individual parts typically associated with this process.

The codes in the table above are directly from the Corporate CAD database and may not reflect all codes included in the Supported Franchise Database or Independent Franchise Databases.